Blyss BLY1 Especificaciones descargar pdf (Pagina 22)

In more detail...

Specications/

Troubleshooting

BLY1 Wireless Alarm System

Type AC/AC Adaptor with 3-pin UK style

Housing material ABS

Rated Supply 230VAC 50HZ supply

Output Extra Low Voltage (AC15V max at 500mA AC)

Troubleshooting

1) Control unit (CU)

2)Wireless Door/Window contact detector (MC)

3)Wireless PIR detector (PIR)

4)Wireless remote control (optional accessory)

Control Panel Power Supply Adaptor

Symptoms Possible causes and cures

Power indicator and all status LEDs are off

without any response

No power supply to unit.

Check connectors to mains and alkaline

battery.

Power indicator does not light up but the sta-

tus LEDs or TAMPER LEDs are on.

Main supply is out. It is operating from alkaline

battery. Check power connections/adaptor.

TAMPER (Red) ashing.

Low backup battery condition;

replace 9V PP3 Alkaline battery as soon as

possible.

No response to wireless detector

transmissions.

Are detectors programmed correctly?

Are PIR Detectors in warm up time (During

the rst 2 minutes from the batteries

installing)?

Are detectors within radio range of the control

unit? Control unit not armed.

Symptoms Possible causes and cures

Does not detect opening of door or window

(Red LED does not ash)

Check that batteries are correctly installed.

Check that magnet is correctly positioned.

Built-in buzzer makes a sound Batteries are low. Replace batteries

Symptoms Possible causes and cures

Does not transmit

(Red LED does not ash).

Check that the battery is correctly installed.

Battery low, replace battery.

Symptoms Possible causes and cures

Does not detect movement

(Red LED does not ash).

Is PIR’s LED turned off?

Is the PIR in its “sleep” condition (See Page 15).

PIR causes false “intruder” alarms.

Check that PIR is not pointed at heat sources

or moving objects, and is not mounted above

a radiator or other heater.

PIR will not trigger alarm when the system

is set.

PIR in “sleep” condition.

Built-in buzzer makes a sound. Batteries are low. Replace batteries.

REMARK: if you have any

problem with the wireless alarm

system, press the RESET switch

inside the control unit. The system

will reset to factory default settings,

but the detectors will need to be

re-programmed again.

Reset Switch

Wireless Alarm System.indd 22 01/06/2012 10:57

1 2 ... 17 18 19 20 21 22 23 24 25 26

Comentarios a estos manuales

Sin comentarios

Blyss BLY1 Especificaciones Pagina 22

Comentarios a estos manuales