10
Getting started...
Installing your System
BLY1 Wireless Alarm System
Power up the Wireless Devices and learning to the CU
Before powering up the devices please read through this information regarding batteries:
1. An adult must carry out battery replacement and installation.
2. Remove exhausted batteries from this product.
3. Do not dispose of batteries in a re, batteries may explode
or leak.
4. Do not short-circuit the battery terminals.
5. Do not mix used and new batteries.
6. Do not mix alkaline standard (carbon-zinc), lithium or
rechargeable batteries.
7. Do not use rechargeable batteries in this product.
8. Do not recharge non-rechargeable batteries.
9. Do not allow any part to come in contact with heat or a direct ame.
10. Do not allow water to come into contact with the batteries or wiring.
11. Install carefully to prevent any damage to the batteries
12. When installing 2x (AAA 1.5V) batteries in the battery compartment, ensure the batteries are
placed as marked (+)(-).
13. Only the recommended batteries should be used.
14. Remove batteries from product when not in use for long periods of time.
15. Keep this product out of the reach of small children.
16. Store unused batteries in their original packaging.
17. Dispose of used batteries responsibly.
The wireless alarm system uses advanced radio technology that under most circumstances
will give more than sufcient transmission range. Before xing the control unit and
detectors in their selected install position, it is recommended to learn each wireless
detector to the control unit. Please follow the procedure below:
Powering up the wireless siren:
* The use of ear defenders is advisable at this stage *
1. Separate the siren’s front cover from the siren’s base to access the battery compartment.
2. Remove battery cover and insert four LR20 “D” size alkaline batteries in correct polarity as
shown indicated in the battery compartment. The siren’s LED will ash to indicate powered
up. Ret the battery cover taking care not to press and release the tamper switch located on
the rear of the siren’s back plate to prevent the siren from triggering an alarm.
3. If the tamper switch is accidentally press and released then move the power switch to the
‘OFF’ position as shown below to silence the alarm. However, move the switch back to ‘ON’
again ready for it to be learned by the control panel:
Battery cover
screw
“ON/OFF”
siren switch
Wireless Alarm System.indd 11 01/06/2012 10:57
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales